Skip to content
All projects

Brake-Bias Adjuster, Western Formula Racing (FSAE)

Replacing the driver's cockpit brake-bias knob with a motor commanded from steering-wheel buttons over CAN — without breaking the 2027 brake-by-wire ban.

Summary

What it is
An electromechanical brake-bias adjuster for the WFR27 car
Role
GLV Electrical (Brake Bias) & Composites Member
Team
2 (me + 1 teammate)
Dates
Sept 2026 – Present
Tools
SolidWorks, CAN (planned interface), FSAE 2027 rules, requirements traceability
Results
Requirements record complete: 12 requirements (F1–F10, M1–M2); two template issues caught. No hardware yet.

Problem

The driver sets brake bias with a knob in the cockpit. I'm replacing that knob with a motor commanded from steering-wheel buttons over CAN — without breaking the 2027 brake-by-wire ban.

What I'm building

  • I'm designing an electromechanical brake-bias adjuster for the WFR27 car: a motor turns the existing Tilton remote cable in place of the cockpit knob, commanded from steering-wheel buttons over CAN.
  • I wrote the Phase 1 requirements record: 12 functional and packaging requirements (F1–F10, M1–M2), each traced to its source with a verification test.
  • I measured pedal-box clearances in SolidWorks (BP26 assembly) to package the actuator.
  • I translated 2027 FSAE rules (brake-by-wire ban, Critical Fastener rules, 2000 N pedal load) into failsafe requirements: bias holds on power or firmware loss, and adjustment locks out while braking.

How it works

  1. 1

    Steering-wheel buttons

    The bias change is commanded from buttons on the steering wheel.

  2. 2

    CAN to the controller

    The command goes over CAN to a controller. CAN is the planned interface.

  3. 3

    Controller to motor

    The controller drives a motor.

  4. 4

    Motor to balance bar

    The motor turns the existing Tilton remote cable in place of the cockpit knob. The cable sets the balance bar.

  5. 5

    Braking force, drawn separately

    Braking force still goes pedal → balance bar → master cylinders. It does not go through the motor.

Steering-wheelbuttonsCANControllerMotorTilton remote cableBalance barBrakepedalMaster cylindersSets the biasBraking force
Block diagram drawn for this page. Thin lines set the bias; the heavy line is the braking force.

Why it's not brake-by-wire

Braking force still goes pedal → balance bar → master cylinders; the motor only changes the balance-bar setting the driver used to turn by hand.

2027 FSAE rules, turned into failsafe requirements

Rules

  • Brake-by-wire ban
  • Critical Fastener rules
  • 2000 N pedal load

Failsafe requirements

  • Bias holds on power or firmware loss
  • Adjustment locks out while braking

Results so far

12
Requirements (F1–F10, M1–M2), each traced to its source with a verification test
2
Issues flagged in the team's bias template

Requirements record complete. No hardware yet.

Flagged two issues

Both are in the team's bias template.

  1. 01

    A 70/30 setting sits outside the template's own 55/45–65/35 range.

  2. 02

    That range implies 1.7–2% bias per turn, vs. 1.4% from thread pitch.

I'm holding motor sizing until on-car torque measurements exist.

Next steps

Target: after Jan 11, 2027

  1. 1Driver board (Altium)
  2. 2Firmware
  3. 3Actuator mount (SolidWorks)
  4. 4Design presentation
  5. 5On-car torque measurement